Table of Contents
Advertisement
12.5 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press inicio pausa+carga
▶
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: "-0-" .
Note: If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.6 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press inicio pausa+carga
1.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→ "Display", Page 20
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press inicio pausa+carga
5.
12.7 Cancelling the pro-
gramme
Press inicio pausa+carga
1.
Open the door.
2.
Remove the laundry.
3.
→ "Unloading the laundry",
Page 29
12.8 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
12.9 Switching off the appli-
Press
▶
.
12.10 Filter system on the
During drying, fluff from the laundry is
collected in the base unit's filter sys-
tem. The filter system protects the ap-
pliance from fluff.
Cleaning the filter system on the
base unit
If the display shows a notification
while the appliance is in operation,
clean the base unit's filter system.
.
Notes
¡ You can clean the filter regularly
system even without the notifica-
tion being shown on the display.
It is not necessary to clean after
each drying cycle.
¡ If you do not clean the appliance
as described, the appliance's func-
tionality may be impaired.
Requirement: The display shows the
following during operation:
Open the base unit → Page 48.
.
1.
Remove the fluff.
2.
.
Make sure that you remove all dirt
from the seal.
ance
.
base unit
operation en
.
29
Advertisement
Table of Contents
