Connectors - Axis Q16 Series User Manual

AXIS Q16 Network Camera Series
Specifications
Function button
Note
Focus assistant is only valid for optional P-iris, DC-iris or manual iris lenses.
Use the function button to activate the following functions:
Leveling assistant - This function helps to make sure the camera is level. To start the leveling assistant, press the button for about
3 seconds. Press again to stop the leveling assistant. The status LED and buzzer signal assist leveling of the camera, see Status LED
behavior and buzzer signal for leveling assistant on page 29. The camera is level when the buzzer beeps continuously.
Focus assistant - This function is used for enabling the focus assistant. To enable the focus assistant, press and very quickly release
the button. Press again to stop the focus assistant. To find out more, see the Installation Guide.

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
Audio input
1 Tip
Balanced microphone (with or without phantom power)
or line, "hot" signal
Audio output
1 Tip
Channel 1, unbalanced line, mono
The internal microphone is used by default; the external microphone is used when connected. You can disable the internal
microphone by connecting a plug to the microphone input.
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, through an event or from the product's webpage.
2 Ring
Balanced microphone (with or without phantom
power) or line, "cold" signal
2 Ring
Channel 1, unbalanced line, mono
30
3 Sleeve
Ground
3 Sleeve
Ground