Problem Solving Guide; Messages; Dispensing/Dispensing Systems - Miele PG 8581 Supplementary Document

6.

Problem Solving Guide

WARNING!
PERSONAL INJURY AND EQUIPMENT
DAMAGE HAZARD
Repairs may only be carried out by Eschmann.
Repairs and other work by unqualified persons
could be dangerous for the user.
The following guide may help you find the reason for a fault
and correct it.
To avoid unnecessary service call-outs, check that the fault
has not been caused by incorrect operation when an error
message first appears.

6.1. Messages

Problem
The display is dark and all
the LEDs are out
The machine has switched
itself off
Next service due on
6.2. Dispensing/ Dispensing Systems
Problem
DOS refill
DOS Vent at the end of the
programme
Programme could not be
started. Vent DOS
18
Cause and remedy
The machine is not switched on.
Switch the machine on using the
A fuse is defective or has tripped
Minimum fuse rating – see data plate
Reset the trip switch
If the mains fuse trips again, call Eschmann.
This is not a fault
If activated, the Auto-Off function switches the machine off automatically after a pre-set
duration to save energy.
Switch the machine on using the
This is not a fault
Eschmann has recommended a date for the next service visit.
Please contact Eschmann to arrange a service visit.
Cause and remedy
During a programme sequence a low level of liquid chemicals in a container has been
identified.
Exchange it for a full container before the start of the next programme.
During a programme sequence a low level of chemicals has been identified.
There may be air in the dispensing system.
Allow the programme to continue to the end.
Vent the dispensing system at the end of the programme.
A programme cannot be started because...
• there is air in the dispensing system
• the dispensing system has been sucked completely dry.
Check level in the supply container and refill or replace it with a full container as necessary.
Vent the dispensing system.
For all fault messages:
If the cause is not remedied and the machine is switched off,
when it is switched back on again the fault message must be
acknowledged with the code. The machine will be locked for
further use until this is done
button.
button.
.
MUW216743-2