Miele PG 8581 Supplementary Document page 13

phase after the main wash (see Programme charts). The reservoir
must be filled and the dispensing system vented for this to occur.

Place the neutralising agent container (red marking) on the open
cabinet door or on a surface which is robust and easy to clean.
Rinse aid dispensed via dosing system
DOS 3 - Marked red

Rinse aid is dispensed from a 5 litre container via the dosing
Unscrew and remove the siphon. Place the siphon on the open
system called DOS 3. The cap or lines on the tubing are
cabinet door.
marked in red. The 5 litre container of rinse aid is connected
to the machine by screwing on the red marked suction tube.

Push the suction tub/float down towards the bottom of the
Replace the empty container with a full one.
container

Push the siphon into the opening of the container and screw it back
Once fitted ensure the tube is pushed to the bottom of the
container. When the container is nearly empty the screen
on tightly. Observe the colour coding.
will display 'DOS refill' and it is time to replace it with a new
 container to the red suction tube.
Wipe up any spilled process chemical thoroughly.
If the chemical is renewed immediately there is no need
to vent, but if delayed for more than one cycle venting

Place the container on the floor next to the machine or in an
becomes necessary.
Place the container on the floor next to the machine or in an
adjacent cupboard. Make sure that the dispensing hose is not
adjacent cupboard. Make sure that the dispensing hose is
not kinked or trapped. kinked or trapped.
Vent the dispensing system as necessary.

Vent the dispensing system as necessary (see "Settings  / Venting
If the DOS3 system is vented, it is important to run at least
one rinse cycle, otherwise foaming will occur.
DOS").
Check consumption regularly by checking the fill levels in the supply
containers and replace containers in good time to avoid the
dispensing system being sucked completely dry.
MUW216743-2 13