Miele PG 8581 Supplementary Document page 10

Opening the door using the emergency release
The emergency release may only be used when it is no longer
Opening the door using the emergency release
possible to open the door normally, e.g. in the event of a power
The emergency release may only be used when it is no
cut.
longer possible to open the door normally, e.g. in the event
of a power cut.
 If the emergency release is operated during a programme cycle,
WARNING!
hot water and cleaning agents can escape.
PERSONAL INJURY HAZARD
Risk of scalding, burning and chemical burns.
If the emergency release is operated during a program
cycle, hot water and cleaning agents can escape.

Risk of scalding, burning and chemical burns.
Push against the door so that less force is needed to operate the
Push against the door so that less force is needed to operate
emergency release.
the emergency release.
Opening and closing the door
Opening the door using the emergency release
The emergency release may only be used when it is no longer
possible to open the door normally, e.g. in the event of a power
cut.
 If the emergency release is operated during a programme cycle,
hot water and cleaning agents can escape.
Risk of scalding, burning and chemical burns.

Push against the door so that less force is needed to operate the
emergency release.

Push the tool supplied in the accessory pack horizontally into the
Push the tool supplied in the accessory pack horizontally into
the gap between the door and lid or worktop. The right hand
gap between the door and the lid or worktop. The right hand edge
edge of the tool must align with the right hand edge of the
display.
of the tool must align with the outer right hand edge of the display.
Push inwards against the unlocking mechanism with the


Push the tool supplied in the accessory pack horizontally into the
tool until you hear the door unlock. The door can now be
Press against the unlocking mechanism with the tool until you hear
gap between the door and the lid or worktop. The right hand edge
opened.
of the tool must align with the outer right hand edge of the display.
the door unlock. The door can now be opened.

If the washer disinfector is switched on, activation of Press against the unlocking mechanism with the tool until you hear
the door unlock. The door can now be opened.
the emergency release can be recorded in the process
If the washer-disinfector is switched on, activation of the emergency
documentation and the following message will appear in the
If the washer-disinfector is switched on, activation of the emergency
release will be recorded in the process documentation and the
display:
release will be recorded in the process documentation and the following message will appear in the display:
Fault: 432
following message will appear in the display:
Machine no.:
Service number:

Switch the washer-disinfector off and then back on again with the
Switch the washer-disinfector off and then back on again
 button.

with the button.
Acknowledge the fault message by entering your lock code.
Acknowledge the fault message by entering your lock code.
Refer to Section 6.4 Advisory codes (cycle interrupts).

Switch the washer-disinfector off and then back on again with the
 button.

Acknowledge the fault message by entering your lock code.
10
Opening and closing the door
Fault: 432
Machine no.:
Service number:
27
Water Hardness & Internal Water Softener
This machine can have its water softener optimised by
configuring it to the hardness of the incoming mains water.
This will have been set by the engineer at installation.
Please refer to the Miele Operating Instructions.
Filling the salt reservoir
Filling the salt reservoir
The machine has an internal water softener, which requires
special regeneration salt to help it refresh the softening
Use only special, coarse-grained reactiva
beads. Only special, tablet regeneration salt is to be used.
of approx. 1 - 4 mm.
Do not under any circumstances use other types of salt such
as table salt, agricultural or gritting salt. These may contain
Do not under any circumstances use othe
insoluble additives which can impair the functioning of the
water softener.
salt, agricultural or gritting salt. These ma
which can impair the functioning of the w WARNING!
EQUIPMENT DAMAGE HAZARD
 Inadvertently filling the salt reservoir
Inadvertently filling the salt reservoir with
cause serious damage to the water softe
cleaning agent will cause serious damage to the
water softener.
Before filling the salt container make sur
Before filling the salt container, make sure
the right packet of reactivation salt.
that you have picked up the right packet of
reactivation salt

1. Open the door to an angle of approx. 45°. This ensures
Open the door to an angle of approx. 45
that the salt flows into the reservoir more easily.
flows into the reservoir more easily.
.
MUW216743-2