At The End Of The Programme; Cancelling A Program - Miele PG 8581 Supplementary Document

A light touch on the relevant button is sufficient to operate the
functions. The buttons can also be pressed and held for approx.
20 seconds.

4.6. At the end of the programme

Display illustrations
All display illustrations shown in these operating instructions are
Note: The Eschmann Dental or Eschmann W T D programme
examples which can be different from the actual display screens
will be available.
shown.
Vario TD Dental Eschmann W T D
Temperature
Temperature
Duration
Duration
A programme is usually completed successfully when the
The control buttons are shown next to the display. The ,  and
Start/Stop buttons are not shown.
following parameters and messages are shown in the
display:
Display line Display content
Top line Programme name.
Middle line Continuously alternating between:
• (Parameter achieved)
• A
0
• Cycle number
Bottom line Programme finished.
The LED in the Start/Stop button also
goes out and the LED in the button
begins to flash. An acoustic tone also
sounds for approximately 10 seconds.
4.7. Cancelling a programme
WARNING!
HEALTH HAZARD
If the programme is cancelled, the items in the
washer disinfector must be reprocessed again.
WARNING!
PERSONAL INJURY HAZARD
Be careful when opening the door.
The wash load could be hot. Danger of scalding,
burning and chemical burns.
Cancelling a programme
Programme cancelled due to a fault  If a programme is cancelled, the items in the washer-disinfector
must be reprocessed again.
The programme stops and an error message appears in the
display.
 Be careful when opening the door.
The wash load could be hot. Danger of scalding, burning and
Take appropriate steps to resolve the fault, depending on its
chemical burns.
cause (see 'Problem solving guide').
The programme stops and an error message appears in the display.
Cancelling a programme manually
Take appropriate steps to resolve the fault, depending on its cause
A programme which is already running should only be
(see "Problem solving guide").
cancelled if strictly necessary, e.g. if the wash load is moving
about significantly.
A programme which is already running should only be cancelled if
strictly necessary, e.g. if the wash load is moving about significantly.
Press and hold the Start/Stop button until the display

Press and hold the Start/Stop button until the display changes to
changes to the following view
the following view:
Cancel programme
No
Yes

Select using the  and  arrow buttons.
Yes

The programme is cancelled when the OK button is pressed. Entry
MUW216743-2
of a code may also be required (see "Further settings / Code")
If no button is pressed for several seconds, or if the process is
cancelled using the  button, the display will revert to the
55˚C
55 °C
50Min
50 Min
value
Operation
Select Yes using the UP and DOWN buttons (
The programme is cancelled when the OK button is pressed.
Entry of a code will also be required. Refer to 6.4 Advisory
codes (Cycle interrupts).
If no button is pressed for several seconds, or if the process
is cancelled using the OK button, the display will revert to the
programme sequence display.
Restarting the programme
Start the programme again or select a new programme.
21
∧ ∨
).
15