Table of Contents
Advertisement
Before first use
Con@ctivity via a direct WiFi connec-
tion (Con@ctivity 3.0)
You can find the necessary informa-
tion on connecting the ventilation
hood in the associated operating and
installation instructions.
Switch the cooktop on.
Touch the 0 sensor control on any of
the numerical displays.
Touch and hold the 0 and 7 sensor
controls on the numerical display at
the same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the time
has elapsed, a progress light appears
during the connection attempt. If the
connection was successful, the
code : appears in the timer display.
If the connection could not be estab-
lished, the timer display will show the
code :. Repeat the steps above.
When successfully connected, 2 and
3 will light up constantly on the ventila-
tion hood.
Quit connection mode on the ventila-
tion hood by pressing the run-on
button.
Con@ctivity has now been activated.
30
With a direct WiFi connection, it is not
possible to connect the cooktop and
the ventilation hood to a home net-
work. If this is desired later, the direct
WiFi connection between the cooktop
and the ventilation hood must first be
reset (see "Before using for the first
time – Con@ctivity" and "Disconnect-
ing the WiFi" in the operating and in-
stallation instructions for the ventila-
tion hood).
Advertisement
Table of Contents
