The Administration - Management Tab; Figure 6-15: Administration - Management Screen - Linksys WAP54GPE User Manual

Wireless-G Exterior Access Point

The Administration - Management Tab

On this screen you can configure the password and SNMP settings.
AP Password
You should change the password that controls access to the Access Point's Web-based Utility.
Local AP Password
User Name. Create a User Name and enter it in the field provided.
AP Password. Create a Password for the Access Point's Web-based Utility.
Re-enter to confirm. To confirm the new Password, enter it again in this field.
SNMP

Figure 6-15: Administration - Management Screen

SNMP is a popular network monitoring and management protocol. It provides network administrators with the
ability to monitor the status of the Access Point and receive notification of any critical events as they occur on the
Access Point.
To enable the SNMP support feature, select Enabled. Otherwise, select Disabled.
Identification
Contact. Enter the name of the contact person, such as a network administrator, for the Access Point.
Device Name. Enter the name you wish to give to the Access Point.
Location. Enter the location of the Access Point.
Get Community. Enter the password that allows read-only access to the Access Point's SNMP information. The
default is public.
Set Community. Enter the password that allows read/write access to the Access Point's SNMP information. The
default is private.
SNMP Trap-Community. Enter the password required by the remote host computer that will receive trap
messages or notices sent by the Access Point.
Chapter 6: Configuring the Wireless-G Exterior Access Point 30
The Administration - Management Tab