Figure 4-3: Ground The Access Point; Figure 4-4: Attach The Access Point To The Wall - Linksys WAP54GPE User Manual

Wireless-G Exterior Access Point
7. Make sure you properly ground the Access Point.
8. Maneuver the Access Point so the two screws on the wall are inserted into the Access Point's wall-mount
slots. Then slide the Access Point down so the screws fit snugly in the slots.
9. Attach two screws (not included) at the top of the mounting plate so the Access Point is securely mounted.
10. Connect the other end of the Ethernet network cable to a switch, router, or other device that supports Power
over Ethernet. The Access Point will then be connected to your wired network.
Now that the hardware installation is complete, proceed to "Chapter 5: Setting Up the Wireless-G Exterior Access
Point," for directions on how to configure the Access Point.
Chapter 4: Connecting the Wireless-G Exterior Access Point
Hardware Installation

Figure 4-3: Ground the Access Point

Figure 4-4: Attach the Access Point to the Wall

9