Audi A8 2010 Maintenance Manual page 18

Audi A8 2010 ➤
Maintenance - Edition 11.2014
– Rear: Position support plates of lifting platform under plastic
mountings -arrow- on underside of side member trim.
Note
The location of the lifting points is indicated by markings stamped
on the side member trim.
2.1.1 Activating jacking mode
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
Procedure:
– Switch on ignition and activate MMI.
– Press function selector button
– Under »Car systems«, navigate through following menu struc‐
ture:
♦ Servicing & checks
– Use MMI rotary pushbutton to select "Air suspension: wheel
change" and set to "on".
Note
Jacking mode is switched off again automatically once a
♦
speed higher than 15 km/h is reached.
If jacking mode is activated for a longer period of time, the
♦
pressure in the suspension struts may dissipate, thereby low‐
ering the vehicle. If necessary, start the engine briefly to
reactivate jacking mode.
14
2. Preparations
.
CAR
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.