Linksys NSS4000 Series Administrator's Manual page 11

• FTP: FTP access state (enabled or disabled).
• NFS: NFS access state (enabled or disabled).
Backup/Snapshots Status
The Backup/Snapshots area displays the following:
• Snapshots: The total number of volume snapshots configured.
• Last Backup: The date and time of the last backup run. If a backup has never been run on the
system, the word "never" appears.
Power Status
The Power area displays the following:
• UPS: The following options are available depending on the current operating condition of the
UPS. For more information about the functioning of the UPS, refer to the UPS documentation.
- No Connection: A UPS is not currently connected to the NSS.
- On Mains: A UPS is connected to the NSS but is not currently being used to power the unit.
The NSS is deriving power from the mains power.
- On Battery (%): The NSS is currently deriving its power from the UPS battery. The
percentage of power still available is also listed and is color-coded according to the amount
of battery remaining.
• RPSU: The following options are available depending on the current operating condition of
the RPSU. For more information about the functioning of the RPSU, refer to the RPSU
documentation.
- No Connection: There is no RPSU installed.
- Ready: An RPSU is installed and is currently available as a backup power source.
- Standby/Fault: An RPSU is installed but is in Standby mode, or, the RPSU is installed and
has some sort of fault condition. For example, the RPSU is connected to the NSS but is
powered off.
- Active: The RPSU is currently being used to provide backup power to the NSS.
- Unavailable: The RPSU is currently providing backup power to another device and is not
available to provide backup power to the NSS.
System Status
The System area displays the following:
• Serial Number: The serial number of the NSS.
• Firmware Version: The current version and date of the firmware installed on the NSS.
Chapter 2: System
Network Storage System (NSS) Administrator Guide
Chapter
2
9