Transportation - Murray EQ2-300 Manual

User manual and warranty card
AIR FILTER REPLACEMENT
Every 25 hours of operation, check the condition of the air filter. The filter must be replaced every
100 hours or earlier if it is contaminated.
Press the catches securing the filter housing or unscrew the bolts securing the filter cover (Fig. 17A).
1. Open the cover 1 (Fig. 17B).
2. Remove the air filter (the air filter is a piece of oil-soaked sponge) 2 (Fig. 17B).
3. If the filter is not damaged:
– - wash the filter sponge element with water and detergent,
– - squeeze the foam element into a clean cloth,
– - soak the filter sponge element with clean engine oil.
4. If the filter is damaged or damaged, replace the filter with a new one.
5. Replace the cover by sliding the catches into the slots on the filter housing or tighten the screw.
LINE ADJUSTMENT
The cables may stretch and contract during use. They should then be checked and properly adjusted
(if adjustment is available on your model). To do this loosen the small locking nut 1 (Fig. 18) and then
depending on your needs:
1 turn the adjusting nut 2 (Fig. 18) counterclockwise: the cable is shortened,
2 turn the adjusting nut 2 (Fig. 18) clockwise: the cord will be extended.

TRANSPORTATION

PREPARATION FOR TRANSPORT
• Before transporting the mower, remove oil, then: cool the engine, remove fuel from the tank,
carburettor and fuel lines.
• The device can only be transported in the working position, i.e. at an angle of up to 15 degrees
above the level.
• The handle may be folded.
Attention! Be careful when folding or unfolding the handle, as the cables may be damaged.
Damaged cables can cause the mower to malfunction and in some cases reduce the safety of use of
the device.
23
English