Construction Of A Lawn Mower - Murray EQ2-300 Manual

User manual and warranty card
operation manual applies to various models of mowers. The mower described may differ from your
purchase. Read the passages that refer to the device model you have.
CONSTRUCTION OF PETROL MOWER
Illustrative drawings can be found on page 3, Fig. 1-2
1 Handle
2 Engine brake lever
3 Clamp lever
4 Starter handle with cable
5 Starter cable attachment point
6 Basket
7 Rear wheel
8 Handle connection nut with housing
9 Water cleaning system connection
10 Front wheel
11 Air filter cover
12 Engine
13 Fuel-filler cap
14 Oil filler cap
15 Muffler
16 Spark plug pipe
17 Basket full indicator
18 Cable adjustment
19 Grass ejection cover
20 Cutting height adjustment lever
21 Suction pump
ASSEMBLY
The mower handle is factory set in the storage position.
 Set the lower handle to the use position, making sure that the handle is between the stops and
tighten it with the wing nut (Fig. 3).
 Set the upper handle to the use position and lock it with the clamping lever. Turning the nut
changes the length of the clamping lever bolt, thus increasing or reducing the clamping force.
Fastening occurs when the clamp is pressed against the handle in the direction of the arrow on
Fig. 4.
Attention! Too short the bolt with a nut may cause the clamping lever not to be tightened,
and consequently damage the lever.
Attention! When unfolding and folding the handle, make sure that the engine brake cable
does not break or bend. A bent or otherwise damaged cord may prevent the mower from
working properly.

Fasten the starter rope handle 4 (Fig. 1) at the attachment point 5 (Fig. 1).
18
English