Hard Disk Connectors: Ide1 & Ide2 - MSI MS-6189 Manual

CHAPTER 2 CHAPTER 2 CHAPTER 2 CHAPTER 2 CHAPTER 2
2.6 Hard Disk Connectors: IDE1 & IDE2
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA/66 (ICH)/
Ultra DMA/33(ICH0) Controller that provides PIO mode 0~4, Bus Master,
and Ultra DMA/33 function. It has two HDD connectors IDE1 (primary) and
IDE2 (secondary). You can connect up to four hard disk drives, CD-ROM,
120MB Floppy (reserved for future BIOS) and other devices to IDE1 and
IDE2. These connectors support the provided IDE hard disk cable.
IDE1(Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can
connect a Master and a Slave drive. You must configure second hard
drive to Slave mode by setting the jumper accordingly.
IDE2(Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
HARDW W W W W ARE INST HARD HARD HARD HARD
2-11
ARE INSTALLA ARE INST ARE INST ARE INST ALLATION ALLA ALLA ALLA TION TION TION TION
1
1