Running SV2 Editor |53
Running SV-2 Editor
Connecting your SV-2 via USB
Before using the SV2 Editor, you must connect your SV2 to a personal com
puter via a standard USB cable.
Please note that not all USB hubs are compatible with SV2. In case you ex
perience troubles when connecting the piano to your computer, remove the
hub and directly connect the piano to an USB port of your computer.
Turning your SV-2 on
For all the features of the SV2 Editor to work, the SV2 must be connected
and turned on before you run the software. Otherwise, only the Backup page
will be available to manage your backup sets.
The computer or the SV2 may enter sleep mode while using the editor, and
connection between them may be interrupted. In this case, please wake
them, then exit and relaunch SV2 Editor. You may set your computer and
SV2 so that they don't go to sleep while working with the SV2 Editor.
Also, please note that your computer might exit from sleep mode when you
turn the SV2 on. This is a normal behavior, since the USB port is sensing the
SV2 returning to an active state.
Launching SV-2 Editor
Locate the application's icon into your hard drive, and double click it.