Korg STAGE VINTAGE SV2S-88 User Manual page 93

Organ
This is a detailed model of the amp of a classic tone­wheel organ. With the
addition of the 3­band EQ, this amp simulation will allow you to create a very
versatile distortion. This amp model is especially suitable for organ sounds.
You can select one of two amp models, or a direct line out from the organ's
preamp. Type 1 is a standard powered amp for organ, producing a warm, fat
tone. Type 2 yields a less colored tone, with more high frequencies than Type
1. Pre Amp is the sound of a direct line out from the organ, without the amp
gain (but with all the other controls).
HINT: When the Organ amp is select, you should choose Bypass as the cabinet. This
would prevent to have at the same time the organ's own cabinet and a guitar cabinet.
However, you are free to experiment with any combination.
Parameters Values
Amp Type Type 1,
Type 2,
Pre Amp
Amp Gain 0...100
Bass ­10...10
Middle ­10...10
Treble ­10...10
Output Level 0...100
Mix
Notes
Type of amp model. Pre Amp bypasses the amp gain.
This adjusts the gain when Amp Type is set to Type 1 or
Type 2. It does not apply if the Amp Type is set to Pre Amp.
If an Expression pedal is connected to the PEDAL 2 con­
nector, you can use it to control the amount of overdrive
and distortion. With higher Amp Gain values, you can
reach heavy distortion; with Amp Gain = 0, the amp will
always remain clean.
Adjusts the bass frequencies.
Adjusts the middle frequencies.
Adjusts the treble frequencies.
Amp's output level.
Adjusts the mix between the direct signal and the effect.
You can make the sound less aggressive by lowering the
amp's sound in the mix.
FX page |85