Advertisement
2.3
Downloading the project image using the LinkIt 2523 HDK as a
removable storage
To update the FreeRTOS image only (SDK project image: iot_sdk_demo.bin) use the LinkIt 2523
development board as a removable disk drive according to the following steps:
1) Connect the LinkIt 2523 development board to your PC with a micro-USB cable.
Navigate to Computer on your PC to check if a new mass storage named MT2523 is available
2)
under Removable Disk, as shown in Figure 4.
Figure 4. LinkIt 2523 module connected as removable disk storage
Open the MT2523 removable storage, then drag and drop the image iot_sdk_demo.bin to the
3)
removable storage to complete downloading the flash.
This document contains information that is proprietary to MediaTek Inc. ("MediaTek") and/or its licensor(s).
Any unauthorized use, reproduction or disclosure of this document in whole or in part is strictly prohibited.
5
LinkIt 2523 HDK User's Manual
© 2015 - 2016 MediaTek Inc.
Advertisement
