Advertisement
Camera data line 0
Set the jumper J1010 to connect the sensor daughterboard using the SPI clock, as
/
shown below.
sensor board clock
Set the jumper J1010 to connect the camera daughterboard using data line 0, as
shown below.
Set the jumper J1011 to connect the sensor daughterboard using the SPI data input, as
Camera pixel clock
shown below.
input / sensor
board data input
Set the jumper J1011 to the camera daughterboard using pixel clock input, as shown
below.
Set the jumper J1012 to connect the sensor daughterboard connection using the
Camera pixel clock
GPIO, as shown below.
output / sensor
board reset
Set the jumper J1012 to connect the camera daughterboard using the camera pixel
clock output or data line 0, as shown below.
Set the jumper J1015 to connect the camera daughterboard using the camera pixel
Camera pixel clock
clock output, as shown below.
output / camera
data line 2
Set the jumper J1015 to connect the camera daughterboard using the camera data
line 2, as shown below.
4.12. USB
LinkIt 2523 HDK has two USB connectors, CON6401 see section 4.16.11, "USB2.0 high speed connector CON6401" and
CON6601 see section 4.16.12, "CMSIS‐DAP USB 1.1 full speed connector CON6601", as shown in Figure 18. The
CON6401 is used to flash the LinkIt 2523 HDK with the LinkIt 2523 Flash Tool.
This document contains information that is proprietary to MediaTek Inc. ("MediaTek") and/or its licensor(s).
Any unauthorized use, reproduction or disclosure of this document in whole or in part is strictly prohibited.
20
LinkIt 2523 HDK User's Manual
© 2015 - 2016 MediaTek Inc.
Advertisement
