Mediatek Labs LinkIt 2523 HDK User Manual page 19

Storage Connect the jumper J1006 to set the storage command line to eMMC, as shown
command below. Connect the jumper J1006 to set the storage command line to micro SD, as
line shown below.
4.11. Camera
Connect the camera daughterboard (see Figure 10) to the camera connector to enable the camera. The sensor
daughterboard features are shared with camera using a jumper switch (see Table 14). The LinkIt 2523 HDK supports
serial interface cameras.
This document contains information that is proprietary to MediaTek Inc. ("MediaTek") and/or its licensor(s).
Any unauthorized use, reproduction or disclosure of this document in whole or in part is strictly prohibited.
19
LinkIt 2523 HDK User's Manual
© 2015 - 2016 MediaTek Inc.