Advertisement
4.15. Connectors
The LinkIt 2523 HDK supports connectors to capture a signal, plug‐in an external component, update an image and more.
This section provides details and pin definitions for the connectors.
4.16.1. UART connector
The jumper J1013 is reserved for user applications that can be configured for different modes, such as UART, GPIO and
EINT. The jumper location is shown in Figure 11.
4.16.2. I2C connector
The jumper J1014 (see Figure 11) is reserved for user applications that can be configured for different modes, such as
GPIO and I2C. The jumper location is shown in Figure 11.
4.16.3. Battery connector CON2102
The user can connect a battery to the connector CON2102 with the pin configuration as shown in Table 17.
Pin number
1
3
5
4.16.4. Camera daughterboard connector CON6201
Connector CON6201 (see Figure 14 and Figure 15) is able to connect camera daughterboard to capture images. The
direction of camera module is to the left, also means camera module on daughterboard should be toward USB
connectors. Users are able to customize the applications by pin assignment Table 22 if no camera daughterboard is at
hand.
This document contains information that is proprietary to MediaTek Inc. ("MediaTek") and/or its licensor(s).
Any unauthorized use, reproduction or disclosure of this document in whole or in part is strictly prohibited.
LinkIt 2523 HDK User's Manual
Table 17. Battery connector CON2101 (see Figure 11)
Description
VBAT
NTC
GND
© 2015 - 2016 MediaTek Inc.
23
Pin number
2
4
6
Description
VBAT
GND
NC
Advertisement
