Electrolux DC6-4 Installation Manual page 16

16
Lift up the door a bit from the bottom edge and remove it from the upper hinged joint, far enough so that the hinge pin
is exposed. The pin has a groove for the control cable.
Pull the door cable (F) with its connecting contact out of the slot in the hinge. The door cable is bared so that it can
be pulled through the slot. Use this part when pulling the cable out.
The door (G) is now free and can be put aside.
Detach the upper hinge (H) with the hinge plate (I). Discard the hinge and plate.
Fit the new replacement hinge with hinge plate on the opposite side. (The hinge and hinge plate must be ordered
from the supplier).
Remove the fan unit (J). The torque screws are located on the interior surface on the top of the drying cabinet. The
screws will become accessible if the hanger section is pulled out a bit.
Installation manual
fig.W01256
fig.W01257