Tektronix Multipaq VX4101A Reference page 10

VX4101A Multipaq
CONFigure Subsystem
Commands CONFigure[1|2|3]([:SCALar]|:ARRay)
:FREQuency[<array size>[,<expected value>[,resolution>]]]
:FREQuency:RATio[<array size>[,<expected value>[,resolution>]]]
:PERiod[<array size>[,<expected value>[,resolution>]]]
CONFigure[1|2]([:SCALar]|:ARRay)
:NDUTy cycle|PDUTCycle|DCYCle [<array size>[,<dcycle
reference>[,<expected value>[,resolution>]]]
:NWIDth|PWIDth [<array size>[,<pwidth reference>[,<expected
value>[,resolution>]]]
:PHASe [<array size>[,<expected value>[,resolution>]]]
:RTIMe|FTIMe|RISE:TIME|FALL:TIME [<array size>[,<low
reference>[,<high reference> [,<expected value>[,resolution>]]]]]
:TINTerval [<array size>[,<expected value>[,resolution>]]]
[:VOLTage]
CONFigure[1|2|11|12|21|22]([:SCALar]|:ARRay)
:TINTerval:DELay:TIME|EVENts[<array size>[,<delay time>|<delay
events>[,<expected value>[,resolution>]]]]]
CONFigure[1|2|10|20]([:SCALar]|:ARRay)
:TOTalize
NOTE: If you specify SCALar in the command, <array size> is not a valid
parameter. If ARRay is specified, <array size> is a required parameter.
Queries CONFigure?
8
Instrument Reference
:AC [<array size>[,<expected value>[,resolution>]]]
:DC [<array size>[,<expected value>[,resolution>]]]
:MINimum [<array size>[,<expected value>[,resolution>]]]
:MAXimum [<array size>[,<expected value>[,resolution>]]]
:PTPeak [<array size>[,<expected value>[,resolution>]]]