Clipboard And Version Manager - Mutable Instruments Ambika Manual

Clipboard and version manager

Press S5 (*versions* command) to bring the version manager.
pt 1 program
copy | swap | paste
The following commands are available for the select object (*part 1 program* in the
example given above):
• copy (*S1*) copies the current item to a clipboard. You can use it to temporarily
hold in memory a version of a patch, or to copy a patch from one part to another.
• swap (*S2*) exchanges the content of the clipboard with the current item. This
allows you to quickly go back and forth between two versions of a patch.
• paste (*S3*) replaces the current item by the content of the clipboard. Note that
there are actually 4 clipboards, one for patches, one for multis, one for programs
and one for sequences.
• << (*S5*) reverts the current item to its previous content. This works like the undo
function available on most computer software. For example, if you create an
amazing patch, and then load by mistake a preset on top of it, you can use this
function to go back in time and retrieve your creation.
• >> (*S6*) works like a redo command. You can use it to cancel an undo command
and move forwards in the versions list.
• keep (*S7*) saves the state of the current item on the undo stack, so that you can
get back to it at a later point in time.
• exit (*S8*) exits the version manager.
version 0
<< | >>
36
| keep | exit