Omron HEM-7156T Instruction Manual page 6

Display/Problem
appears
appears
flashes
flashes
flashes
appears
flashes
appears or the
monitor is turned
off unexpectedly
during a
measurement
Nothing appears on the
display of the monitor.
5
Possible Cause
The monitor has malfunctioned.
The monitor cannot connect to a
smart device or transmit data
correctly.
The monitor is waiting for pairing with
the smart device.
The monitor is ready to transfer your
readings to the smart device.
More than 48 readings are not
transferred.
The date and time is not set.
There are 60 readings in memory to be
transferred
Batteries are low.
Batteries are depleted.
Battery polarities are not properly
aligned.
Solution
Press the [START/STOP] button again. If "Er" still appears,
contact your local OMRON representative.
Follow the instructions shown in the "OMRON connect"
app. If the "Err" symbol still appears after checking the
app, contact your local OMRON representative.
Refer to section 5 of instruction manual
your monitor with your smart device, or press [START/
STOP] button to cancel pairing and turn your monitor off.
Open the "OMRON connect" app to transfer your
readings.
Pair or transfer your readings to the "OMRON connect"
app so you can keep them in memory in the app, and this
error symbol disappears.
Replacing all 4 batteries with new ones is recommended.
Refer to section 4 of instruction manual
Immediately replace all 4 batteries with new ones. Refer
to section 4 of instruction manual
Check the battery installation for proper placement. Refer
to section 4 of instruction manual
for pairing
.
.
.