Table of Contents
Advertisement
Tools/Outils/Herramientas
Plus/Plus/Más:
• 5/16" Lag Bolts with Flat Washers [Min 500 lb (227 kg) Load Bearing]
Tire-fonds de 5/16" avec rondelles plates [capacité de charge min 500 lb (227 kg)]
Pernos de fijación de 5/16" con arandelas planas [para carga mín de 500 lb (227 kg)]
• Socket Wrenches/Clés à douilles/Llaves de dados
• Framing Nails/Clous de cadrage/Clavos para estructuras de madera
• 2x6 Bracing/Renfort 2x6/Refuerzo de 2x6
• Plated Plumbing Fittings
Raccords plaqués de plomberie
Conexiones de plomería enchapadas
• Wood Screws/Vis à bois/Tornillos para madera
Before You Begin
WARNING: Risk of property damage. Do not modify the vanity in any way.
Doing so will compromise the structural stability of the vanity and may cause
property damage.
WARNING: Risk of property damage. Select 5/16" lag bolts with a minimum of
500 lb (227 kg) load bearing with washers. Select lag bolts with a length that can
safely clear any obstacles in the wall. Calculate the proper length of the lag bolts
by adding the following: 1-1/2" (3.8 cm) backing material + finished wall
thickness + hanger thickness.
NOTICE: If a lavatory/vessel will be installed: The plumbing must be roughed into
the plumbing cutout area of the vanity. Refer to the lavatory/vessel roughing-in
and the vanity roughing-in for proper placement. The water supply and drain lines
must be installed before installing the vanity.
NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
NOTICE: To avoid the risk of product damage, the finished wall must be straight and
plumb. If the finished wall is not straight and plumb, the vanity will not be properly
supported and will cause misalignment of the lavatory and doors.
NOTE: The dimensions provided in this guide are for a 34" (86.4 cm) vanity height
with the lavatory (K-2952) installed. The height from the top of the vanity to the floor
will be 31-1/2" (80 cm). If an alternate height is desired, calculate the desired height
of the backing material and brackets.
Observe all local plumbing and building codes.
Provide a 2x6 brace behind the finished wall. The height from the top of the 2x6
brace to the floor must be 31-1/2" (80 cm).
Kohler Co. reserves the right to make revisions in the design of products without
notice, as specified in the Price Book.
Avant de commencer
AVERTISSEMENT: Risque d'endommagement du matériel. Ne pas modifier le
meuble de quelque manière que ce soit. Ceci compromettrait la stabilité du
meuble de toilette et pourrait causer des dommages matériels.
Kohler Co.
Siliconized Acrylic Caulk
Mastic acrylique siliconé
Sellador acrílico siliconado
Painters Tape
Ruban de peintre
Cinta adhesiva
de pintor
3
1/4" Drill Bit
Mèche de 1/4"
Broca de 1/4"
1091335-2-D
Advertisement
Table of Contents
