Buttons, Indicators & Leds - Biostar Z790 VALKYRIE Manual

Note
» » Ensure proper pin connecting to your LED device, wrong connection may damage your LED device or
motherboard.
» » The 12V_LED connector supports to 5050 RGB LED strips with the maximum power rating of 3A
(12V).
» » The 5V_LED connector supports up to 300 LEDs WS2818B individually Addressable RGB LED strips
with the maximum power rating of 3A (5V).
» » Please use the Vivid LED DJ software to control the LEDs. For detailed software setting information,
refer to chapter 3.3 .
2.8 Buttons, Indicators & LEDs
On-Board Buttons
Indicators
LEDs
Below LEDs are controlled by AURORA program. Please refer to Chapter 3.3 for more detail
software setting.
SW_PWR:
Touch this button to turn-on/off the
system.
SW_RST:
Touch this button to reboot the system.
CLR_CMOS:
Press the button 1~2 Seconds to load the
BIOS defaults.
BIOS POST Code Indicator:
The indicator will show POST code while
booting. Please refer to Chapter 4.3 for all
the BIOS POST codes.
1. RGB LED Header(5V/12V)
2. ARMOR GEAR LEDs
3. South Bridge LEDs
Chapter 2: Hardware installation | 23
Z790 VALKYRIE