Biostar Z790 VALKYRIE Manual page 16

Install an Expansion Card
You can install your expansion card by following steps:
• Read the related expansion card's instruction document before install the expansion
card into the computer.
• Remove your computer's chassis cover, screws and slot bracket from the computer.
• Place a card in the expansion slot and press down on the card until it is completely
seated in the slot.
• Secure the card's metal bracket to the chassis back panel with a screw. (This step is only
for installing a VGA card.)
• Replace your computer's chassis cover.
• Power on the computer, if necessary, change BIOS settings for the expansion card.
• Install related driver for the expansion card.
Note
» » Please be note that you will need to use M.2 type screwdriver if you want to install or uninstall the
screw. It is recommended not to use a screwdriver that does not meet the specifications, otherwise
the screw may be damaged.
Install M.2 COOLING Heatsink
Steps of Removing the M.2 COOLING Heatsink:
Step 1: Before inserting the M.2 SSD card, please loosen the screws on the edge of the heat
sink and remove the heat sink.
Step 2: Insert the M.2 SSD card into the M.2 slot, and use screws to lock the M.2 SSD card on
the motherboard.
Step 3: After installing the M.2 SSD card, place the heatsink and tighten the screws to fix the
heatsink on the motherboard.
Note
» » Please follow the installation instructions of M.2 COOLING Heatsink and remove the M.2 COOLING
Heatsink to install the M.2 SSD card onto your motherboard.
16 | Chapter 2: Hardware installation