Advertisement
2.4-1 Power Switch
Connect to a 2-pin push button switch. This switch had the same feature
with JRMS1.
2.4-2 Reset Switch
Reset switch is used to reboot the system rather than turning the power ON/
OFF. Avoid rebooting while the HDD LED is lit. You can connect the Reset
switch from the system case to this pin.
2.4-3 Power LED
The Power LED is lit while the system power is on. You can connect the
Power LED from the system case to this pin. When the system enters
suspend mode, the power LED will blink.
2.4-4 Speaker
Speaker from the system case is connected to this pin.
2.4-5 HDD LED
HDD LED shows the activity of a hard disk drive. Avoid turning the power
off while the HDD led is lit. You can connect the HDD LED from the system
case to this pin.
2-25
Advertisement
