Maintenance; Routine Maintenance; Filter Lifetime - Philips AUT3234 User Manual

b. Battery lifetime indicator
Status
There is enough battery
The battery is low
c. Reset button
To reset the filter lifetime, long press the reset button for 5 seconds. You will
hear a beep, and the indicator of CBPA filter lifetime flashes blue. Short press
the reset button again to select the filter that needs to be reset.
When the indicator of the selected filter flashes, long-press the reset button
for 3 seconds. You will hear a beep, and the indicator will show constant blue
light. This means the filter lifetime has been reset successfully.
VI. Maintenance

1. Routine maintenance

- Organic solvent such as gasoline etc. shall not be used for wiping the housing
of the device. If cleaning is required, please gently wipe the surface of the product
with a wet cloth after it is disconnected from the power supply.
- If the system is not used for more than 2 days, turn on the faucet and allow the
water to run for at least 5 minutes to flush the filters and the system.
- If the system will not be used for an extended period, take out the lter cartridges,
seal them with plastic wraps, and store them in the refrigerator (not in the freezer).
Turn off the three-way ball valve, turn on the faucet to empty the system, and
take out the batteries. Before using it again, allow the water to run for at least
10 minutes to flush the filters and the system.

2. Filter lifetime

Note
For the best performance, please change your filter cartridge according to the
filter lifetime indicator, or the filter replacement cycle suggested below. When a
signi cantly lower ow rate is observed, we recommend changing the lters as well.
This system can only work with Philips filters.
Indicator
Constant blue light
Flashing blue light
10
Sound alert
N/A
There will be beeps whenever
the faucet is turned on,
reminding you to replace the batteries.