Philips AUT3234 User Manual page 8

This system should be placed on a stable and at surface. Keep the system away
from heat. It shall not be placed in a place that may have in ammable gas leakage.
a. Press down the collets and pull out the plugs
of the water inlet and outlet holes in the back
of the system.
b. Connect the water inlet and the three-way ball valve.
Measure the length of the 1/4" pipe you
need to connect the system and the
three-way ball valve, and cut it accordingly
with a pipe cutter. Insert the other end of
the 1/4" pipe which has been connected
with the three-way ball valve into the water
inlet hole in the back of the system. Use a
clip to secure the pipe at the hole.
Note: The inlet water pressure should be within 0.1-0.4 MPa. If the pressure is too
low, a pressure booster should be installed before the system. If the pressure
is too high, a pressure relief valve should be installed before the system.
The pressure relief valve and extra pressure booster need to be purchased
separately.
6