•
•
•
6.3 Dimension and electrical ports
See the following figure for dimensions of the OS 531 main unit. The unit comes with two electrical connectors:
USB Type-C port: On the right-hand side of the OS 531 in the front view, used to charge the OS 531 and
•
transfer data.
Headset jack, At the bottom of the OS 531 handle, reserved to connect the wireless headset through the
•
supplied audio cable when the headset runs out of power.
7
Before you start for the first time
Before you use a new OS 531 to detect leaks for the first time, charge the device and perform the initial device setup.
7.1 Charging the device
OS 531 is a battery-powered device and partially charged before delivery. If the battery power is low, charge it via the
USB Type-C port on the right-hand side of the device. Please use the USB cable and one of four charging adapters
supplied in the delivery package to charge.
7.2 Performing initial setup
Steps:
LMS: Text, displayed when the OS 531 is in the LMS mode.
Person: Only applicable to the OS 531 in the LMS mode. Icon, displayed when a
technician is logged into the LMS.
Laser: Icon, displayed when the laser pointer is turned on.
11