Setup Menu - Lexmark X850E Reference Manual

Menu item Purpose
Job Acct Stat Prints a listing of all job statistics
stored on the hard disk or clears all
statistics on the hard disk.
Warning:
only if Job Accounting is not set to
MarkTrack™.
Note: This menu item only appears if
the hard disk is not write or read/write
password protected.
Activate Hex Helps isolate the source of a print job
Trace problem. With Hex Trace selected, all
data sent to the MFP is printed in
hexadecimal and character
representation. Control codes are not
executed.
Coverage Provides an estimate of the
Estimator percentage of coverage of cyan,
magenta, yellow, and black on a page.
The estimate is printed on a separator
page.

Setup Menu

Use the Setup Menu to configure a variety of MFP features.
Menu item Purpose
Printer Language Specifies the default printer language
used to communicate data from the
computer to the MFP.
Note: Setting a printer language as the
default does not prevent a software
application from sending print jobs that
use the other language.
Resource Save Specifies what the MFP does with
downloaded resources, such as fonts
and macros stored in RAM, if the MFP
receives a job that requires more
memory than is available.
Setting Resource Save to On causes
the MFP to reset and returns the LCD
to the home screen.
Settings
Clear appears as a value
Values and descriptions
Print
Clear
Off*
On
Values and descriptions
PCL Emulation*
PS Emulation
Off*
On
73
Prints all statistics available for
the most recent print jobs.
Deletes all accumulated job
statistics from the hard disk. As
the MFP deletes all stored job
statistics, the message
Clearing job accounting
statistics appears as the
jobs are deleted.
Touch Activate Hex Trace to
enter Hex Trace mode.
To exit Hex Trace mode, turn the
MFP off, wait 15 seconds, and
then turn the MFP on.
Percent coverage is not printed.
Prints the estimated percentage
of coverage for each color on
the page.
PCL emulation—Uses a
PCL interpreter for
incoming host
communications.
PostScript emulation—
Uses a PS interpreter for
incoming host
communications.
The MFP retains
downloaded resources only
until memory is needed. It
then deletes those
resources associated with
the inactive printer
language.
The MFP retains all
downloaded resources for
all printer languages during
language changes and
MFP resets. If the MFP
runs out of memory, 38
Memory Full appears.