Electrical Connection - Electrolux DC6-8HP Q Series Installation Manual

14

6 Electrical connection

The electrical installation may only be performed by qualified personnel.
Electrical connection of the appliance must be done in accordance with electrical safety regulations.
We recommend that the mains cable be equipped with a ground fault interrupter.
The manufacturer disclaims all liability if the electrical connection is not done in the manner prescribed in this
User Manual.
Connection to the mains must be via an all-pole switch to 400V 3N AC.
Connection is only permitted to a mains with maximum impedance of 0.239 ohm.
Total power 3.5 kW.
Fuse 13 A.
• Remove the front plate. The front plate is secured with four screws at the top and four screws at the bottom.
• Install a 5-wire connecting cable to the terminal block on the PCB as indicated in the wiring diagram. Route the ca-
ble to and through the marked bushing in the roof plate.
• Thread the door cable through the hole (see figure) and connect as indicated in the wiring diagram.
• Reinstall the front plate.
1 Bushing in roof plate for feed cable
2 Circuit board
3 Terminal block
4 Thread the door cable through the hole
5 Door cable
6 Front plate
Installation manual
6 5
1
2
3
4
fig.W01377