Routine Maintenance - Lexicon CP-3 Plus Owner's Manual

PLUS
CP-3 Digital Surround Processor
Other than occasional replacement of the batteries in the remote control
units, the CP-3 requires minimal maintenance. Use a soft, lint-free cloth
PLUS
slightly dampened with warm water and a mild detergent to clean the
exterior surfaces of the unit.
Do not use alcohol, benzene or acetone-based cleaners
or any strong commercial cleaners.
Avoid using any abrasive materials such as steel wool or metal polish. If the
unit is exposed to a dusty environment, a vacuum or low-pressure blower
may be used to remove dust from the CP-3
If severe power surges or sags cause problems with CP-3
storage, or you simply want to start with a clean slate, you can restore
factory presets into the User registers with the following procedure.
This will erase any programs you have stored in the User registers,
as well as all setup and calibration values.
Note any settings you want to re-use before proceeding.
With the Expanded Remote control, turn the CP-3
back ON and press the SETUP button within two seconds. (Make sure you
do not block the infrared receiver on the CP-3
holding down SETUP until the display reads:
(If you want to resume normal operation without restoring all defaults, this
is your last chance. Release SETUP and press SETUP again to resume
normal operation.)
To restore defaults, release SETUP and press STORE to clear and reload
User registers, and to restore all factory settings of Volume, Balance,
Contrast, Configuration, etc.
The display will flash an INITIALIZING message then read:
Press SETUP to resume normal operation.
All of the adjustable parameters in the CP-3
values assigned when it cleared final Quality Control at the factory. Using
the values notated on the Installation Worksheet at the end of this manual,
follow the initial setup procedure starting on Page 18.
If you cannot solve functional problems through these procedures, consult
your dealer or Lexicon/Customer Service Department.
DO NOT OPEN THE UNIT.
DOING SO WILL VOID YOUR WARRANTY,
AND MODIFICATIONS MAY RENDER THE UNIT UNSERVICEABLE.
PLUS exterior.
PLUS
* RESTORE MODE *
SETUP TO EXIT
* RESTORED ALL *
SETUP TO EXIT
PLUS have now been reset to the
PLUS memory
PLUS OFF. Turn the unit
front panel.) Continue
Troubleshooting

Routine Maintenance

Restoring Defaults
51