LW Scientific Combo V24T Instruction Manual

Advertisement

Before Operating

1
LW Scientific instruments have a one (1) year limited warranty. This warranty is not valid on normal wear and tear, cosmetic
damages caused by chemicals, solvents, and/or cleaning solutions, as well as acts of God.
Please register your product online at: www.LWScientific.com/warranty_form.
Important: Warranty information must be completed within 30 days of purchase.
2
Remove the centrifuge from the shipping container and inspect for any possible shipping damage. If the centrifuge
appears to be damaged, please contact your distributor immediately.
Open the lid by pressing on the front center of the lid until it clicks (to close, press down again until it clicks).
The Combo V24T normally ships with the 12-place test tube rotor installed. Ensure the black thumbscrew is tight before
operating as seen on page 2.
WARNING: Ensure the rotor is securely fixed to the rotor shaft. Failure to properly secure rotor could lead to personal
injury or damage to the centrifuge.
P. 770.270.1394
P. 770.270.1394
This symbol refers to hazards that may be encountered when using this product.
CAUTION means that damage to product or environment could occur
WARNING means that injury or contamination could occur
F. 770.270.2389
F. 770.270.2389
865 Marathon Parkway Lawrenceville GA 30046
Combo V24T Centrifuge
A
Start
Stop
Rotor
select
speed
time
Short
Spin
B
865 Marathon Parkway Lawrenceville GA 30046
Instruction Manual
Lid
Main Power Switch
Display Power
Start / Stop
Rotor Select
Speed
Time
Short Spin
Select
Descrease Value
Increase Value

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Combo V24T and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for LW Scientific Combo V24T

  • Page 1 WARNING means that injury or contamination could occur LW Scientific instruments have a one (1) year limited warranty. This warranty is not valid on normal wear and tear, cosmetic damages caused by chemicals, solvents, and/or cleaning solutions, as well as acts of God.
  • Page 2 If there is excessive vibration or noise, shut off the unit immediately, check the troubleshooting tips, and contact LW Scientific if not resolved. Spin only balanced loads. Make sure that tubes are placed opposite each other. Proper sample balancing will improve sample separation and will extend the life of the centrifuge.
  • Page 3 The Combo V24T motor shaft has been greased prior to shipping. It is recommended to put a light coating of grease onto the motor shaft every few months to allow for easy rotor changes. Any type of household grease will work, but a white lithium grease is best because it makes the metal surfaces friction-free and protects against rust.
  • Page 4 Specifications Max. Speed (HIGH): 12,000 RPM (+/- 600) Max. Speed (LOW): 5,000 RPM (+/- 200) Max. Volume: 12 3ml to 15ml test tubes 24 75mm capillary tubes Optional 24 2ml microtubes Input Voltage: 110v / 220v auto-switching Fuse: 6.3 amp / 250 volt Height: 11 inches (277mm) Width:...

Table of Contents