Octane Fitness Q45 Service Manual page 31

Issue
"Err6", "Err7", "Err8", or "Err9"
is displayed on the console,
indicating limit switch issues.
"Err11" is displayed on
the console, indicating a
communications issue.
Console buttons are not
responding or are sticking.
Possible Cause
Faulty limit switch assembly
on stride motor.
Faulty wiring harness.
Faulty console key.
What to Do

Unplug the unit.

If the unit is new (that is, just out of the box),
unplug and re-plug the limit switch assembly at
the stride motor (Figure 2.30) to ensure a good
connection.

If the unit is not new and has previously been
working without displaying these errors, check
the plug-in for the limit switch assembly (Figure
2.30). If it is connected, disconnect it and plug
in a new limit switch and test. If the error is
resolved, complete the installation of the new
limit switch according to the directions in Section
III.

Unplug the machine. Unplug and re-plug
all connections to the controller board and
servomotor (Figure 2.31, older units, or Figure
2.32, newer units.).

If the issue is not resolved, you will need to
replace the wiring harness according to the
directions in Section III.

Replace the keypad overlay according to the
directions in Section III.
Q45 2.3