Reset; Security Codes; Trouble Conditions; Volume - ADT 2 Gig Go! Control Quick Manual

2 Gig Go! Control Quick Guide
Select the [CLOSE] button to exit through the menus back to the home screen.
For more information on this topic please visit the complete

Reset

It is recommended that you clear the system status after an alarm event.
To reset your panel, arm the panel or, after disarming, press [CLEAR ALARM HISTORY] on the Alarm
Memory screen.
For more information on this topic please visit the complete

Security Codes

To set-up the user codes:
At the Home screen, press [SECURITY].
At the Security screen, press [MENU].
At the Menu screen, press [TOOLBOX].
Enter the [Master Code] to access the Toolbox.
On the Toolbox (1 of 3) screen, press [USER MANAGEMENT].
Press one of the [ADD USER] buttons.
Enter a unique four (4) digit code for the new user code. Then press [OK].
Enter the code again to confirm it. Then press [OK].
At the Confirmation screen, press [OK] to return to the User Management screen.
For more information on this topic please visit the complete

Trouble Conditions

Your security system is able to automatically test itself for power failures, low batteries, nonworking
sensors, and communication troubles with the central monitoring station. When a trouble condition is
detected, the trouble indicator will turn on and the keypad will beep every 10 seconds.
ALERT ICON] to view the trouble condition. Use the up and down arrows to scroll through the trouble conditions.
After viewing the trouble events, press [OK] to acknowledge the trouble condition and silence
the trouble beeps.
For more information on this topic please visit the

Volume

http://alpha.adt.com/help/280[11/14/2018 8:14:39 PM]
2 Gig Go!Control manual.
2 Gig Go!Control manual.
2 Gig Go!Control manual.
2 Gig Go! Troubleshooting
Press the [TROUBLE
page.