Remote Control - GE 20444 User Manual

Unlock Position
Lock Position
If you want to control multiple fans using separate remotes and do not have separate
circuit breakers for each fan, contact customer service at
FCC ID: 2AAZPFAN61T3SP1
17

Remote Control

Operate Fan Using Transmitter Code Pre-set by Factory
( Keep Switch Placed In Unlock Position )
Step 1. Restore power to ceiling fan.
Step 2. Install two 1.5-volt AAA batteries provided.
Step 3. Press the "
of the transmitter to operate the fan.
Step 4. Press the "
A dimmer feature is provided on the light .
Press all the way down to get maximum light .
Note: The blue light will illuminate to indicate the transmitter
is working.
In Case Of Interference With Other Fans, You Can Change The
Transmitter Code To Operate This Fan Only.
Step 1. Shut off power to all fans at wall switch. At the circuit breaker,
reset the power (turn OFF and back ON) for the fan you are
re-programming.
Step 2. Within 30 seconds of resetting the power, turn wall switch back
on, switch the lock
"lock " position. Push the Sync "
until the light on the fan flashes 3 times.
Step 3.Repeat steps for each fan that needs re-programming.
" button located on the front
" button to operate the light .
/unlock button on the back of the transmitter to
" button for about 5-10 seconds,
1-866-885-4649
.