Remote Control Operations; Remote Functions - GE 20451 User Manual

REMOTE CONTROL OPERATIONS

"Sync" switch:

REMOTE FUNCTIONS

indicator (summer use)
This LED turns on to indicate the fan
is running counterclockwise. The
downward airflow will provide
a cooling breeze in summer.
"
This button is for changing the direction
of rotation of the fan.
" " button
Turns fan on and reduces the fan speed.
" " button
This button controls the light and also
controls the brightness setting. Press and
release the button to turn the light ON or OFF.
Press and hold the button to set the desired
brightness: the light will slowly illuminate to
maximum light output and then stop when
holding the button, then release the button
and hold it again until it reaches minimal
illumination where it will automatically stop
again. The light button has an auto-resume,
it will stay at the same brightness as the
last time it was turned off.
Note :
.
To prevent damage to transmitter, remove the batteries if not used for long periods.
.
Replace batteries as a simultaneous set – always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of
different types.
.
Please contact your local batteries recycling center for proper battery disposal information.
14
Operation Instructions
" O " and " I " dip switch
" button
Step 1. Restore power at circuit breaker and turn the wall switch to the on
position (if using wall switch) to test for proper operation,
Step 2. Open the battery compartment cover, and then install two 1.5-volt
AAA batteries (LL) provided in the remote control bag. Ensure the batteries
are installed correctly with regard to polarity (+ and -).
Step 3. Check " O " and " I " dip switch: For this fan the dip switch should be
in the "I" position, allowing for dimming of the light. Place the switch in the
"0" position to turn the dimming feature off if you do not want the dimming
feature.
Step 4. Close the battery compartment cover and see below diagram for the
function of each button on the transmitter.
Step 5. Select a location to install the transmitter holder (KK), Mount the
transmitter holder (KK) using the wood screws (MM) provided.
IMPORTANT: If the remote control is not operating correctly, please follow
the steps on page 16, item 5 for syncing the switch. Use the corner of the
battery cover to press the "Sync" switch for syncing function.
Note: This Fan and Remote has a dimming function for the light. You can
control the brightness of the light with the
remote. Please see below for Remote Functions.
This indicates which fan speed is running.
This LED turns on to indicate the fan is
running clockwise. The airflow will force
warm air downward without a
noticeable breeze in winter.
This button turns the fan on and off.
Turns fan on and increases the fan speed.
This button delays the light turning off
for approximately 5 seconds, enabling
you to exit your room before the light
turns completely off.
" " button
on the hand held
Fan speed indicators
indicator (winter use)
" " button
" " button
" "
button