Download Print this page

Hantek CC-800 Operator's Manual

Ac/dc current probe

Download this manual

CC-800 AC/DC CURRENT PROBE

OPERATOR'S MANUAL

Table of Contents

Page 1 CC-800 AC/DC CURRENT PROBE OPERATOR’S MANUAL...
Page 2: Application Procedure
INTRODUCTION The multimeter/oscilloscope can directly measure the DC current of no more than 800A and the AC current of no more than 500A through the AC/DC current probe, and the measurement frequency is up to 5KHz. When measuring current with this current probe, there is no need to destroy the current loop or peel off the insulating layer.
Page 3: Application Notes
test is 5×1000=5000mA. When connecting an oscilloscope to measure AC current, you can use the measurement function of the oscilloscope to measure the peak-to-peak value and effective value of the AC current. For details, please refer to the operating manual of the corresponding oscilloscope.
Page 4: Safety Information
Optional accessories: adapter BNC/banana-KJJ Electrical characteristics  :(23±5℃, 70%R.H. maximum) Effective measuring range 10mV/A: 1A to 40A, DC or rms AC 1mV/A: 1A to 500A, rms AC 1A to 800A, DC Accuracy System accuracy: the sum of the accuracy of the current probe and the accuracy of the digital multimeter or oscilloscope For example, if the conductor being measured carries a current of 1A, set the current probe to 10mV/A and the output signal is 10mV.
Page 5 The products comply with the following EU standards: 89/336/EEC (electromagnetic compatibility) and 93/68/EEC (CE marking) improved 73/23/EEC (low voltage).