Terminal Description; Lane Control Board Terminal Description - HIKVISION DS-K3G501LX Series User Manual

DS-K3G501LX Series Tripod Turnstile User Manual
Warning
Terminal PE should connect to a ground wire to avoid hazard when people touching the device.
Note
The cable bare part should be no more than 8 mm. If possible, wear an insulation cap at the end
●
of the bare cable. Make sure there's no bare copper or cable after the wiring.
The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output
●
terminal reversely.
To avoid people injury and device damage, when testing, the ground resistance of the
●
equipotential points should not be larger than 2 Ω。

4.3 Terminal Description

4.3.1 Lane Control Board Terminal Description

The picture displayed below is the main control board diagram.
11