Hitachi D10VF Safety Instructions And Instruction Manual page 12

English
7. M ounting and dism ounting of the bit
For keyed chuck (Fig. 2)
(1) Open the chuck jaw s, and insert the bit into
the chuck.
(2) Place the chuck w rench in each of the three
holes in the chuck, and turn it in the clockw ise
direction (view ed from the front side). Tighten
securely.
(3) To rem ove the bit, place the chuck w rench
into one of the holes in the chuck and turn it
in the counterclockw ise direction.
(4) If it is hard to loosen the sleeve, fix the
spindle using the open-end w rench, hold the
sleeve firm ly, and turn it in the loosening
direction (counterclockw ise w hen view ed
from the front).
For keyless chuck (Fig. 4)
(1) Open the chuck jaw s, and insert the bit into
the chuck.
To open the chuck jaw s, hold the ring w hile
turning the sleeve in the counterclockw ise
direction (view ed from the front side).
(2) Firm ly grasp the ring and turn the sleeve in
the clockw ise direction. Tighten securely.
(3) To rem ove the bit, firm ly grasp the ring and
turn the sleeve in the counterclockw ise
direction.
8. Installing the side handle (Fig. 5)
A Side handle is supplied w ith drill. (except
D10VF)
It can be installed on either side of the tool for
right or left handed use.
To install the side handle, thread it into the
socket on the desired side of the tool and
tighten it securely.
9. Check the rotational direction (Fig. 6)
The bit rotates clockw ise (view ed from the
rear side) by pushing the R-side of the push
button.
The L-side of the push button is pushed to
turn the bit counterclockw ise.
(The and
L
R
body.)
10.Attaching the angle unit. (Optional
accessory for D13VF and D13VG)
(1) Rem oving chuck from drill (Fig. 7)
12
m arks are provided on the
Drill chuck
Chuck
Tighten
Wrench
Fig. 2
Open End
Wrench
Fig. 3
Ring
Sleeve
Loosen
Tighten
Fig. 4
Loosen
Fig. 5
Fig. 6
Loosen
Loosen
Side Handle
Tighten
L m ark
Siw tch Trigger
R m ark