Intelligent Memory Circuit; Charging; Power Bank Function - Fenix E-SPARK Manual

indicate locked status.

Intelligent Memory Circuit

The light memorizes the last selected mode. When turned on again the previously used mode will
be recalled.

Charging

Remove the tail protection cover to reveal the male Type-C port for discharging and the female
Type-C port for charging the light.
1. Plug the USB Type-C socket of the charging cable into the female Type-C port of the light and
the other end of the charging cable into an electrical outlet.
2.The indicator will display red while charging, and will turn green when fully charged.
3. The normal charging time is approximately 2 hours from depletion to full charging with a
5V/1A adapter.
4. All modes are available when charging, but the charging time will be prolonged.
5. Be sure to replace the tail protection cover once charging is completed to maintain the
dustproof and waterproof ability.

Power Bank Function

1. Switch off the light and remove the tail protection cover, and plug the male Type-C port of the
light into the Type-C port of the digital device to be charged.
2. Single click the side switch to start discharging.
3. The indicator will be constantly on when discharging, while the light can not be turned on.
3. Be sure to replace the tail protection cover once discharging is completed.
Note:
1. The male Type-C port of the light ONLY supports discharging and the female Type-C port of the
light ONLY supports charging. Both charging and discharging power is 5V/1A, and an adapter or
power bank with 5V/1A or higher power can be used to charge the light.