Download Print this page

Signature Hardware 459071 Installation

Vessel vanity top

Advertisement

Quick Links

VESSEL VANITY TOP INSTALLATION
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures and
plumbing. Signature Hardware accepts no liability for any
damage to the floor, walls, plumbing, vanity cabinet, sink,
counter top, or personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the vanity for damage. If any
damage is found, contact our Customer Relations team
at 1-866-855-2284.
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
Ensure that your bathroom floor is adequately
supported, and the finished floor is level.
Ensure that there is adequate support behind the
bathroom wall before installation.
NEVER LIFT THE VANITY TOP FLAT
NEVER CARRY THE VANITY TOP FLAT
PLANNING
Use the vanity's PDF specification sheet as a reference
when planning your layout. The specification sheet can
be found and downloaded from the product page on
our website.
Because the vanity specification measurements are
approximate and slight variations may occur, we highly
recommend performing any rough-in procedures with
the vanity on site.
TOOLS AND MATERIALS:
Neutral Cure
Silicone Sealant
Damp Cloth
Vessel Vanity Top Installation Instructions
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the 459071 and is the answer not in the manual?

Questions and answers

Summary of Contents for Signature Hardware 459071

  • Page 1 fixtures and when planning your layout. The specification sheet can plumbing. Signature Hardware accepts no liability for any be found and downloaded from the product page on damage to the floor, walls, plumbing, vanity cabinet, sink, our website.
  • Page 2 VESSEL VANITY TOP INSTALLATION STEP 1: VANITY TOP INSTALLATION 4. If you are installing a side-splash and/or back-splash, 1. If replacing the top on an existing vanity, ensure that place a generous amount of silicone sealant on the all adhesive has been removed from where the old back of it and press it into place against your bathroom counter was attached.
  • Page 3 VESSEL VANITY TOP INSTALLATION Step 2: Sink Installation 1. Carefully place your vessel sink upside down on the 4. Remove any excess sealant to complete the sink counter top. Apply a generous amount of silicone installation. sealant to the base of the sink where it will rest on the counter.

This manual is also suitable for:

462394456233456235462400459068