Advertisement
DOUBLE BOWL SEMI-RECESSED VANITY
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures and
plumbing. Signature Hardware accepts no liability for any
damage to the floor, walls, plumbing, vanity cabinet, sink,
counter top, or personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the vanity for damage. If any
damage is found, contact our Customer Relations team
at 1-866-855-2284.
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
Ensure that your bathroom floor is adequately
supported, and the finished floor is level.
Ensure that there is adequate support behind the
bathroom wall before installation.
NEVER LIFT THE VANITY TOP FLAT
NEVER CARRY THE VANITY TOP FLAT
Double Bowl Semi-Recessed Vantiy Installation Instructions
PLANNING
Use the vanity's PDF specification sheet as a reference
when planning your layout. The specification sheet can
be found and downloaded from the product page on
our website.
Because the vanity specification measurements are
approximate and slight variations may occur, we highly
recommend performing any rough-in procedures with
the vanity on site.
TOOLS AND MATERIALS:
Marker*
Tape Measure*
Neutral Cure
Stud Finder
Level
Silicone Sealant
Wood Shims
Drill*
Screwdriver*
Damp Cloth
*not included
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Signature Hardware DOUBLE BOWL SEMI-RECESSED VANITY
Summary of Contents for Signature Hardware DOUBLE BOWL SEMI-RECESSED VANITY
- Page 1 fixtures and when planning your layout. The specification sheet can plumbing. Signature Hardware accepts no liability for any be found and downloaded from the product page on damage to the floor, walls, plumbing, vanity cabinet, sink, our website.
- Page 2 DOUBLE BOWL SEMI-RECESSED VANITY Step 1: Cabinet Installation 1. Determine the location where you would like to install 3. Place the vanity in the installation location. Verify that your vanity. the vanity cabinet is level. If the vanity is not level, adjust the feet (if applicable) or use wooden shims to adjust as necessary.
- Page 3 DOUBLE BOWL SEMI-RECESSED VANITY Step 2: Counter Top Installation 1. Apply a bead of silicone sealant around the top edge 3. If you are installing a side-splash and/or back-splash, of the vanity cabinet. place a generous amount of silicone sealant on the back of it and press it into place against your bathroom wall.
- Page 4 DOUBLE BOWL SEMI-RECESSED VANITY Step 3: Sink Installation 1. Carefully place your semi-recessed sink upside 5. For stone tops, such as marble and granite, it is down on the counter top. recommended that you apply a high-quality sealer to protect from staining and discoloration. Stone sealer should be reapplied once or twice per year, depending upon usage.
- Page 5 DOUBLE BOWL SEMI-RECESSED VANITY 5. Repeat steps 1-4 to install the second sink. 3. Turn the sink back over, placing it inside the sink’s cutout and adjust the sink as necessary until centered. Once in position, press the sink firmly into place.
Need help?
Do you have a question about the DOUBLE BOWL SEMI-RECESSED VANITY and is the answer not in the manual?
Questions and answers