Signature Hardware CEDAR CLOSET ORGANIZER Installation Instructions

BEFORE INSTALLING
Read entire cedar closet organizer installation
instructions. Observe all local building and
safety codes.
For the following installation instructions it is
assumed that any old fixtures have been
removed and any repairs to the closet have
been completed.
INSTRUCTIONS
Unpack and inspect the product for any
shipping damages. If you find damages, do not
install. Contact Customer Service at
1.866.855.2284. If you need assistance or have
questions while installing your cedar closet
organizer, contact Customer Service.
We recommend consulting a professional if
you are unfamiliar with installing hardware
fixtures. Signature Hardware accepts no liability
for any damage to the closet or organizer, for
personal injury during installation.

TOOLS AND MATERIALS:

Tape Measure
Drill
Pencil
Stud Finder
Level
Drywall Anchors
CEDAR CLOSET ORGANIZER
Safety Glasses
Screwdriver
IMPORTANT INFORMATION
This system was designed for linens, clothes, and pantry items.
Placing excessively heavy items in your closet may lead to
structural failure.
Knots, checking, and light cracking are typical characteristics of
cedar and do not warrant a legitimate cause for return or refund.
If scent wears off, lightly sand with a fine grain sand paper to
revitalize scent.
BASIC SHELVING UNIT INSTALLATION
1. Determine the height and location of the bottom shelf.
Drill pilot holes through the peg holes in the lower supports.
2. Attach the bottom shelf to the lower supports with the 2"
screws. Make sure that the grooved side of the pole is facing
away from the shelf.
Note: If you plan to add an adjacent shelf, place an L-bracket
on the screw before attaching the she supports.
3. Attach the middle shelf to the upper and lower supports.
Keep the screw loose so that the remaining shelves can be
screwed in squarely.
4. Attach the top shelf to the top of the upper supports.
5. Repeat steps 2 through 4 to attach the remaining supports.
Fully tighten the screws for the top and bottom shelves.
6. Locate the wall studs and mount the top, middle and bottom
shelves into at least one stud. If there are no studs in the
appropriate positions, use drywall anchors to mount the
organizer according to manufacturer's recommendations.
7. To install an additional shelf, rest one end on the support and
tap the other into place. The pegs should rest in
the notches
Cedar Closet Organizer Installation Instructions 1