Grandview Large Stage MBII Installation Manual

Note :
When connecting to Rs232 or Rs485, if there is any motion that
cannot be controlled by the screen, please adjust the screen,
please adjust the two control lines;
Wiring loop resistance is less than 20Ω;
Do not run in parallel with strong interference sources
232 port setting: 2400, n, 8, 1 A data string should be sent
twice consecutively.
Wireless control :
Press the up button, the screen will rise.
Press the stop button, the screen stop.
Press the down button, the screen down.
Code pairing / deleting (factory pairing is successful):
Long press the cycle button for 3 seconds, the screen is jogged once to enter the code-matching state; within 10 seconds, the
remote control up and stop buttons are also pressed, and the screen is jogged again to complete the code-matching; the code
deletion is the same as the code-matching operation, odd times The operation is code pairing; even code deletion.
Intelligent electronic stroke positioning (this product can set the up and down stroke of the fabric through the remote control)
Operation method:
Upward stroke setting: Positioning setting key (light on)
Stop → Positioning setting key (light off) → Upward travel record success
→
Downstroke setting: Positioning setting key (light on)
→ Stop → Positioning setting key (light off) → Downstroke recorded successfully
Adjusting method of fabric retracting (upper limit) and upfolding (lower limit):
If it is really necessary to adjust the limit height due to the installation environment or site limitation, you can use the motor
positioning adjustment key to rotate the knob on the motor limiter; the limiter adjustment knob is located in the 12 round hole
next to the power cord outlet.
Adjustment
hole
Power cable
Pay attention:
To confirm the accuracy and security of the screen position, It is necessary to control the screen up and down after
adjusting every half turn of the button, Check if the position is moving correctly;
Be careful when adjusting the screen retracted height. Excessive adjustment will cause the lower rod to snap into
the casing and cause serious damage to the screen or the lower rod falling;
Be careful when adjusting the unfolding height of the screen. Always keep the fabric 1.5 turns or more around the
tube to ensure that the fabric does not fall;
Electrical parameters: Voltage Ac220 ~ 230V 50 /60Hz , Current 1.5A;
Wireless remote control (F): voltage 3V, using battery CR2032X2, transmission frequency; 868MHz, effective control
distance of about 15 meters;
GRANDVIEW CRYSTAL SCREEN CO.LTD.
NO 43.S,Guomao Ave.Hualong,Panyu,Guangzhou,GuangDong.P.R.C
After sales service Tel:020-84899499
;
UP
DOWN
Positioning Settings Key
Wireless transmitter
→
Up key → Up and down remote control to the desired position →
Down arrow key → Remote control up and down to the desired position
White button
Retracted height(lower limit)
Motor
Clockwise Down
Counterclockwise Up
Yellow button
Unfolding height (upper limit)
Clockwise Up
Counterclockwise Down
Large Stage MBII Installation Manual
Intelligent RF control with external motor
Reminders
Thank you for purchasing Grandview products. Please read the instructions carefully before
installation and use, and collect it after reading for future use;
This product must be installed by a qualified professional after the feasibility assessment of
the environment, electricity, structure, etc.;
Do not disassemble or replace the original spare parts at will: If there is any fault, please
contact the after-sales ser vice department.
Model:LS-MBFxxxII(xGxx)