General Operation And Set-Up; Full Manual Set-Up - Nexus STANDARD MP V3 User Manual

set the cut off point between low conductors and medium
conductors. For example in some cases hammered gold coins
may be preferable to be set on the meter as low conductors
(despite that normally they can read as medium-low conductors),
so that all other targets can be ignored without potential loss of
hammered silver and hammered gold coins.
This type of setting will be useful on sites littered with useless
non-ferrous targets with conductivity higher than the desired
small gold and hammered silver coins.

General Operation and Set-Up

Having assembled the Nexus, inserted batteries and connected
the headphones, The Nexus is ready for use. The Nexus
Standard MP V3 is designed exclusively for use by highly
experienced users. No metal detector, however powerful, will
operate at its best unless it is set up properly for the conditions in
which it is to be used. To obtain the best results and maximum
depth and sensitivity to desired targets, the Nexus Standard MP
V3 must be properly tuned to the site and the settings to achieve
this are set out below.

Full Manual Set-Up

Firstly, ensure that no metal is in close proximity to the coil. It is
also advisable to carry out the tuning and setting up of the Nexus
Standard MP V3 away from other metal detectors or potential
sources of electronic interference. Turn the detector on. A tone
will be heard and the RGB meter will flash. The tone will fade and
the meter bar will settle after a couple of seconds. To check the
condition of the batteries, turn on the Battery Check. After the
7.