Assembly And Preparation - Nexus STANDARD MP V3 User Manual

Assembly & Preparation
Assembly & Preparation
The Nexus Standard MP is supplied boxed and ready for quick
assembly by simply attaching the two lower stem poles to the top
one, tightening the collars and attaching the coil to the lower stem
section, using the plastic 4 bolt and friction washers supplied and
tightened by hand so that coil is held at the correct angle to the
stem; the coil cable plug is inserted into the socket in the control
box and then tighten the knurled ring, taking care when winding
the cable around the stem that the cable is not strained.
The centre stem pole is of the same tube diameter as the top one
and can be left off in circumstances where a short stem is
needed; it is meant for use on steep sites, river banks, caves,
ditches and similar conditions.
The detector is supplied with a drop in 10 AA battery holder that
can be used for all types of AA size batteries, (alkaline or
rechargeable); a charging socket is provided to the battery box
for connecting a charger unit. To insert or change batteries
remove any three of the thumb plastic screws from the base lid of
the battery box (the battery box is below the arm cup at the top of
the detector stem) and loosen the fourth screw. Turn the cover to
2.