Installation Of The Lamps; Installation - EuroLite D-16 User Manual

Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

INSTALLATION OF THE LAMPS

For the installation, you need two 120 V/300 W G-6,35 lamps.
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the fixation screw(s) of the service lid on top of the housing.
Step 2: Remove the service lid.
Step 3: Rotate the lampholder so far that the lamp-socket points upwards.
Step 4: Insert the first 120 V/300 W G-6,35 lamp into the lamp-socket.
Step 5: Rotate the lampholder so far that the lamp-socket points upwards.
Step 6: Insert the second 120 V/300 W G-6,35 lamp into the lamp-socket.
Step 7: Replace the service lid and tighten the screw(s).

INSTALLATION

Mount the projector with the mounting-bracket to your trussing system. For safety reasons use an additional
safety-rope. Adjust the desired inclination-angle via the mounting-bracket and fix the bracket-screws.
This device falls under protection-class I. Therefore it is essential that the yellow/green conductor gets
connected to earth.The electric connection must be carried out by a qualified employee.
In general, lighting effects should not be connected to dimming-packs.
Do not operate this device with opened service lid!
10